My 75-Gallon Reef, 2016 — Gallery and the Story of the Rebuild
This gallery shows my 75-gallon reef tank as it looked in 2016. Near the end of 2015 and into early 2016, I decided I wanted a slightly larger tank with a center overflow, so I tore down my 55-gallon reef and replaced it with a 75. The photos here are of that second system: less rock, no sand in the display, a new multi-tier sump in the basement, and corals that responded with some of the best growth I had seen in a home tank.
Every reef tank is a set of decisions about flow, filtration and maintenance, and this one was a deliberate change of direction from the 55. Below is the story of the rebuild and the reasoning behind each change, along with some notes on photographing a bare-bottom reef.
Why rebuild instead of upgrade?
The 55 had been running well, but it had limits I wanted to fix. Its overflow and layout restricted how water moved through the tank, it carried a sand bed and a lot of live rock, and it ran on a single sump. Rather than modify it piece by piece, I decided to replace the display entirely with something a little bigger and designed around the flow pattern I wanted. I spent a few weeks buying new hardware and planning a major renovation of the sump at the same time.
A rebuild is a big undertaking in a reef tank, because every coral, fish and invertebrate has to be kept alive while the old system comes down and the new one goes up. The way to make that manageable is to have somewhere stable to hold the livestock in the meantime, which in my case was the basement sump.
How the swap went
The tear-down went fairly quickly. I consolidated all of the corals and fish into the sump in the basement, which was already running and full of mature water. With the display empty, I took it down and set up the new 75 in the family room. Once the new tank was set up and had water circulating, I tied it into the original sump, so the livestock and the new display shared the same water while I built the new sump system.
That approach avoids one of the biggest risks of moving a reef: putting animals into new, unseasoned water. The biological filtration lives on the rock and in the sump, not in the glass box, so keeping the old sump running during the change meant the corals and fish never had to cope with a cycling tank.
What is a center overflow?
An overflow is how water leaves the display tank to drain down to the sump. In many tanks it sits in a back corner or along the back wall. A center overflow is a tower or box in the middle of the back pane, or sometimes in the middle of the tank, that draws water evenly from both sides.
The advantage is flow. Water returning from the sump can be directed from the ends towards the middle, and surface water from across the tank is skimmed into the overflow, which helps remove surface film and keep oxygen exchange high. It also lets you build two separate rock structures, one on each side, with open water in between, which suits corals that need strong, even flow around them.
Why go bare-bottom?
With the 75, I removed the sand bed from both the display and the sump. Sand looks natural and houses useful animals, but in a tank with strong flow it can be blown around, and it traps detritus, which slowly releases nutrients such as phosphate and nitrate back into the water. A bare glass bottom can be siphoned clean, lets you run much stronger flow without sandstorms and makes it easier to see exactly how much waste is settling.
The trade-off is appearance and habitat. Bare-bottom tanks look less like a natural reef, and they cannot house sand-sifting gobies, burrowing animals or the fauna that live in a deep sand bed. In practice, coralline algae and encrusting corals often colonise the bottom over time, softening the look. I did end up putting some live sand into the largest sump, for specific invertebrates I was holding there, which gave me a place for sand-dwelling animals without putting sand in the display.
Less rock, more flow
I also cut down on the amount of live rock in the display. Many reef tanks are packed with rock, partly for filtration and partly because it looks full, but dense rockwork creates dead spots where water barely moves and detritus collects. Less rock means more open water, cleaner surfaces and better flow around every coral.
Flow matters to corals in several ways. It brings food and oxygen to the polyps, carries away waste and mucus, and keeps sediment from settling on coral tissue. Many SPS corals in particular grow better and colour up more strongly in strong, turbulent flow. Live rock still did its job as biological filtration, but with the sump system carrying much of the load, I did not need the display packed with it.
Building a multi-tier sump
With the 55, I had one sump. For the 75, I wanted a multi-tier system that could hold more livestock and more equipment. A tiered layout uses height as well as floor space: water flows from the display down into one tank, then on through others stacked or stepped at different levels, before the return pump sends it back up.
That gave me separate areas for different jobs. The largest sump held the live sand and the invertebrates I was keeping there; other sections held equipment and extra coral space. More water volume also adds stability, because every change in temperature, salinity or chemistry is diluted across more water and happens more slowly.
I built a cantilever stand for the second tier, and used the space to store my RO/DI make-up water. Reef tanks lose fresh water to evaporation every day, and it has to be replaced with very pure water, usually made with reverse osmosis and deionisation, so the salinity stays constant. Having that make-up water stored right next to the sump made top-off simple and reliable. It also kept a reserve of pure water on hand for mixing new salt water, so water changes never had to wait for the RO/DI unit to catch up.
How automation kept the chemistry stable
As the tank matured it did very well. I had solid coral growth, and with the automation in place I was able to keep chemistry levels very steady for well over a year. In a reef tank, stability matters more than any single number: corals cope with a parameter that is slightly off far better than with one that keeps swinging.
Automation helps by removing the human gaps. Automatic top-off replaces evaporated water before salinity can creep up. Controllers monitor temperature and pH and switch heaters, fans and lights. Dosing pumps add small amounts of alkalinity and calcium supplements throughout the day rather than in large weekly doses, matching what the corals use. The result is a tank whose chemistry barely moves from one day to the next, which is the environment in which stony corals grow best.
Why put the sump in the basement?
Running the plumbing from a display in the family room down to sumps in the basement is more work at the start, but it pays off every day afterwards. The basement can hold far more water volume than a cabinet under a stand, which was the whole point of the multi-tier design. It also moves the noisy, messy and hot equipment out of the living space: return pumps, skimmers, reactors and heaters all sit downstairs, where the hum of pumps and the gurgle of drains are not heard in the room where people relax.
There are practical benefits for maintenance as well. Water changes, salt mixing, cleaning the skimmer and swapping filter media all happen in one place, on a concrete floor where spills are not a disaster. The trade-off is that the return pump has to push water up a full storey, so it needs to be sized for that height, and every pipe joint between floors must be reliable. A good basement system also includes a way to stop water siphoning back down if the pump stops, so the sump does not overflow during a power cut.
How big should a sump be?
As big as space allows. Earlier, with the 55, I said that ideally I would want a sump with around five times the display area, and I settled for about twice. The principle is the same here: total water volume is one of the cheapest sources of stability in a reef system. Temperature drifts more slowly, salinity changes less with evaporation, and a mistake in dosing or feeding is diluted across more water before it can harm anything.
A large sump also gives flexibility. It can hold a refugium for macroalgae and small invertebrates, extra space for growing out coral frags, room for reactors and other equipment, and a quarantine area for new arrivals. In my case, the largest sump held live sand and invertebrates that would not have suited the bare-bottom display, so the system as a whole kept the benefits of sand without its drawbacks in the main tank.
What a tank swap teaches you
Rebuilding a reef forces you to look closely at everything that has grown up in it. Pieces of rock come out covered in sponges, tubeworms and coralline algae; corals that have spread over their neighbours have to be separated; and hidden detritus under the rockwork shows exactly how much waste a sand bed and dense rock were holding. That kind of hidden build-up is one of the strongest arguments for a bare-bottom display with more open space, which is the direction I chose for the 75.
It is also a chance to rethink coral placement. Corals that had been shaded or crowded in the old layout could be placed with better light and flow, and colonies that had been stinging each other could be given more room. A fresh layout is one of the simplest ways to give established corals a boost, and it is a good moment to remove any pests, such as nuisance anemones or flatworms, that have been hiding in the old rock. It is also the best time to photograph every colony on its own, outside the display, as a record of size and colour before it goes back in.
Why I took the 75 down
In the end I took the system down to travel. I was leaving for an extended period, and I did not think the chances of success were good with a novice reefkeeper stopping in to look after it. A mature reef tank can run for days on its own, but over weeks or months, small problems such as a failed pump, a stuck float switch or a sick fish need someone who recognises them and knows what to do.
Taking a healthy tank down is a hard decision, but it is often the responsible one. Corals and fish can be rehomed with other reefkeepers or local stores while they are thriving, rather than lost to a slow failure while the owner is away. Many of the lessons from this tank, from bare-bottom displays to tiered sumps, carried straight into how I think about reef systems today.
Photographing a bare-bottom reef
A bare-bottom display changes the look of photos. With no white sand bed, there is less bright surface to bounce light around the tank, and the bottom of the frame can look dark or reflective. The upside is cleaner, simpler images with fewer distractions, where corals stand out against open water and dark glass.
The same rules apply as in any reef tank: room lights off, the lens close to clean glass, white balance set manually to suit the lights, and a shutter speed fast enough to freeze moving polyps. Strong flow, which is one of the strengths of a tank like this, means corals sway more, so it helps to pause the wavemakers briefly while photographing and remember to turn them back on.
Why did you replace the 55-gallon with a 75?
I wanted a slightly larger tank with a center overflow, less rock, no sand bed and a multi-tier sump.
How did you move the livestock?
All corals and fish were consolidated into the basement sump while the new display was set up and plumbed in.
What is a bare-bottom reef tank?
A reef display with no sand bed, which allows stronger flow and easier removal of detritus.
What is a multi-tier sump?
A sump system using several connected tanks at different levels to add volume, equipment space and livestock space.
How long did the 75-gallon run?
It held very stable chemistry for well over a year before I took it down to travel.
What is RO/DI make-up water?
Purified water made by reverse osmosis and deionisation, used to replace evaporation without changing salinity.
- Blane Perun, “75 Gallon Reef Tank”, TheSea.Org (rebuild, sump and automation notes)
- Blane Perun, “55 Gallon Reef Tank”, TheSea.Org (the system this tank replaced)
Blane Perun has been exploring Earth’s oceans and marine life for over 25 years. Founder of TheSea.Org in 1999, underwater photographer, coral aquaculture pioneer, and explorer of 80+ countries.
About Blane Perun →