Reef Tank Alkalinity — The Parameter Your Corals Use Up Every Day
Alkalinity in a reef tank is a measure of the bicarbonate and carbonate dissolved in the water, the raw material stony corals and coralline algae use to build their skeletons. Natural seawater sits at roughly 6.6–7 dKH depending on location (the global surface average is about 2.3 meq/kg, or 6.6 dKH), and most reef tanks are kept somewhere between about 7 and 11 dKH. Growing corals pull alkalinity down every day, so it has to be replaced by dosing or water changes. The single most important rule: keep it stable. Swings of more than about 1 dKH a day stress corals more than a steady value at either end of the range.
What is alkalinity in a reef tank?
In reef keeping, “alkalinity” (often written alk, KH or dKH) means carbonate alkalinity: the water’s capacity to neutralize acid, which in seawater comes mostly from bicarbonate (HCO₃⁻) and carbonate (CO₃²⁻) ions. Those same ions are what corals pull from the water and combine with calcium to lay down calcium carbonate skeleton.
That gives alkalinity two jobs. It buffers pH, so the water resists sudden swings, and it is a building block. In a tank full of growing stony corals, the building-block job is the one that drives your routine: alkalinity is consumed constantly and needs replacing.

What is the ideal alkalinity for a reef tank?
There is no single perfect number. Natural seawater is roughly 6.6–7 dKH depending on location, and many successful reefs run anywhere from roughly 7 to 11 dKH. Laboratory guidance from equipment makers commonly quotes 8–12 dKH for reef aquaria.
| Tank type | Typical alkalinity target | Notes |
|---|---|---|
| Fish-only / soft corals | ~7–9 dKH | Low demand; water changes often enough |
| Mixed reef | ~8–10 dKH | Most common range |
| SPS-dominant | ~7.5–9.5 dKH (low-nutrient systems often lower) | Stability is critical |
| Coral growth push | ~9–11 dKH | Higher alk with adequate nutrients |
The detail matters less than consistency. Pick a target inside the normal range and hold it there. See our dKH guide for choosing a number by tank type.
Why does alkalinity drop in a reef tank?
Every bit of stony coral skeleton, coralline algae and clam shell that grows uses alkalinity and calcium in a roughly fixed ratio. A tank with a few soft corals may lose very little; a mature SPS tank can consume one or more dKH per day. Alkalinity can also fall if calcium carbonate precipitates out of the water on heaters and pumps, which happens when alk, calcium or pH are pushed too high. See calcium precipitation.
How is alkalinity related to calcium, magnesium and pH?
Alkalinity and calcium are used together, so they should be replaced together, usually with a balanced two-part solution, calcium reactor or kalkwasser. Magnesium helps keep calcium carbonate from precipitating on its own; if magnesium is low, alk and calcium can be hard to hold up. And pH tends to rise slightly when you add carbonate and fall when alk is consumed or CO₂ is high.
How do you test reef tank alkalinity?
Hobby titration kits and handheld colorimeters both work well if used carefully. Test at the same time of day, because alk can drift between day and night as photosynthesis and calcification rates change. In a new or changing system, test every day or two until you know your consumption rate; in a stable tank, two or three times a week is common. Consistency of method matters more than brand.
How do you raise or lower alkalinity?
To raise it, dose sodium bicarbonate (baking soda), sodium carbonate (soda ash) or a commercial two-part solution, or use kalkwasser or a calcium reactor. Full methods are in how to raise alkalinity in a reef tank. To lower it, the safest move is simply to stop or reduce dosing and let the corals use it up; partial water changes with salt mixed at a lower alk also help. Avoid adding acid.
What should alkalinity be in a reef tank?
Most reef tanks are kept at roughly 7–11 dKH. Natural seawater is roughly 6.6–7 dKH. Choose a target in that range and keep it steady rather than chasing a particular number.
Is 12 dKH too high for a reef tank?
It is high but not automatically dangerous. Problems appear when alkalinity is high and nutrients are very low, or when it swings quickly. Many SPS keepers prefer 8–9.5 dKH.
What happens if alkalinity is too low?
Below about 6–7 dKH, coral and coralline growth slows, and pH becomes less stable. Very low alkalinity can stress or kill stony corals.
How fast can I raise alkalinity?
By no more than about 1–1.4 dKH per day. Bigger, faster changes can shock corals.
Is alkalinity the same as KH?
In reef keeping, yes: KH, dKH and alkalinity are used interchangeably. Strictly, KH refers to carbonate hardness. See KH vs dKH.
Why does my alkalinity keep dropping?
Growing corals and coralline algae consume it. A steady drop is a sign of healthy growth and means you need regular dosing to replace it.
Does alkalinity affect pH?
Yes. Adding carbonate raises pH slightly, and alkalinity buffers pH swings. But pH also depends heavily on CO₂ in the room air.
How often should I test alkalinity?
Daily or every other day when setting up dosing, then two or three times a week in a stable tank.
- Hanna Instruments. Saltwater aquarium water parameter guidelines.
- Holmes-Farley, R. “Reef Aquarium Water Parameters” and alkalinity articles, Reefkeeping magazine.
- Bulk Reef Supply. Sodium bicarbonate dosing instructions: maximum daily change.
- Fine, R.A., Willey, D.A. & Millero, F.J. (2017). Global variability and changes in ocean total alkalinity from Aquarius satellite data. Geophysical Research Letters, doi:10.1002/2016GL071712 (2014 global surface mean 2,299 µmol/kg).
- Cooke, K.M. et al. (2026). Alkalinity enrichment stimulates calcification and linear extension in Acropora cervicornis. Scientific Reports, doi:10.1038/s41598-026-44817-6 (ambient Biscayne Bay seawater about 2,460 µmol/kg).
Blane Perun has been exploring Earth’s oceans and marine life for over 25 years. Founder of TheSea.Org in 1999, underwater photographer, coral aquaculture pioneer, and explorer of 80+ countries.
About Blane Perun →